CTB-500
The Clean Burn Model CTB-500 waste oil boiler has an input rating of 500,000 BTU/hr and an output rating of 372,000 BTU/hr. The CTB-500 is UL listed for use in central heating systems. It can be used in combination with any Clean Burn boiler to create a system perfectly sized for any facility.
The CTB-500 is the largest of it’s product line. You spend 30 minutes cleaning every 1000 hours of operation. It is uniquely designed for installation flexibility. Engineered for use as a single boiler unit, or as part of a combination of CTB-500 boilers working as a larger system.
MODEL INFORMATION
FEATURES
Three-pass heat exchanger creates more heat efficiency
Low-mass water design provides quick start -up
Patented burner engineered exclusively for waste oil
System is pre-wired, ready for installation
Narrow cabinet designs provide installation flexibility
Unequaled service and support from Clean Burn Distributors
SPECS
| Model CTB-500 | Specs. |
|---|---|
| BTU/hour input: | 500,000 / 146.5 kW |
| BTU/hour output: | 372,000 / 109.0 kW |
| Fuels | Used oils: Crankcase,ATF, hydraulic Fuel oils: #2, #4, and #5 fuel oil |
| Heating Surface | 97 sq. ft. / 9.0 sqM |
| Boiler water volume | 20.6 gal. / 78 L |
| Design water flow per coil | 37 gpm / 140 lpm |
| Cabinet dimensions | 66.38″ L x 40″ W x 42″ H 169cm x 102cm x 107cm |
| Overall dimensions (with burner/breach/plumbing) |
86.13″ L x 43.5″ W x 47.85″ H 219cm x 111cm x 122cm |
| Approx. Weight | 1600 lbs. / 725.7 kg |
| Electrical Requirements | 115 VAC 60 Hz single phase* *230V/ 50Hz units also available |
| Maximum oil consumption | 3.57 GPH / 13.5 lph |
| Stack size | 10″ / 25cm |
| Air compressor required | 2.5 CFM @ 25 PSI 4.25 m3/h @ 1.7 bar |
| Recommended clean-out | 1000 hours |
*Values indicated above are nominal. Actual values will vary depending on fuel and installation.
RESOURCES
